![]() ![]() Replace "PP" with the port number your machine listens on (usually 7 or 9). Likewise, replace 192.168.1.255 with the actual broadcast address of the network (192.168.1.255 is the broadcast address when the machine has an IP of 192.168.1.x and subnet mask of 255.255.255.0). ![]() Substitute AA:BB:CC:DD:EE:FF with the actual MAC address of the computer which you wish to boot remotely. Note that the full path to "/usr/sbin/wol" is important. If you have local or remote Telnet/SSH access to your router, you can wake up a machine on the LAN by using the following command: Note: This is the preferred method to send WOL magic packets remotely. If you don't see the WakeOn-type options in your BIOS, usually somewhere in Power Management, your motherboard may not support WOL. Consult your motherboard's manual and BIOS screen (DEL at startup, usually). This feature, if optional, must be enabled in your BIOS otherwise WOL isn't going to work. Wake On LAN is usually disabled by default in most PCs. Once this step is working, you can go on to making WOL work when you are outside your LAN, such as at a cafe or another remote location. Hibernate, Standby, and Power-off the WOL computer, while clicking Send on the second computer, to test each mode to make sure WOL is working. Repeat the previous steps and go over the trouble-shooting tips until they work before proceeding. The WOL computer should respond with a pop-up box showing a packet was received. Use the command 'ipconfig /all' if you don't know what this is. MAC address of LAN adapter on WOL computer.0.0.0.0 for Subnet Mask (select from drop-down).IP Address of WOL computer for Host Name. ![]() On the second computer, open WOL Magic Packet and on the Send tab, put in:.On the WOL computer, open WOL Magic Packet and on the Receive tab, click the green Start button.Install it on both the computer you are using and a second PC on the same physical LAN. Get ready to test your set-up by using a utility like WOL Magic Packet Sender (free).Now the computer can normally be started from Hibernate, Standby, or PowerOff modes via a special management packet. ![]() Press OK until you are back at Network Connections. Check the second and third boxes to enable WOL.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |